Network Security

VMS 2.0 docs recommend 3 servers because of the CSPM limitations and the need for NT 4.0. Does VMS 2.1 solve all that allowing it all to be installed on one server?thanksAaron

hi.i need to access my pix 520 through http in the inside network, the configuration that i have is the following:http server enablehttp 0.0.0.0 0.0.0.0 insidethere is something more???thanks,,,,,,,

what state is the PIX in after issuing the following commands:clear xlateclear arpThis PIX is in production with multiple interfaces.Thanks,Guest

I'd like to to know if all PIX SW are installable on every HW .For example I'd like to know if a pix 6.2.2 on a 515 is different from a pix 6.2.2 on a 506 or 501thanks

Configuring a PIX via TFTP - the documented method doesn't work. PIX v6.0(1)Version 6.0 & 6.1 of the doc reference the "configure net" command i.e. configure net 10.1.1.1:/tftp/config/pixconfigV6.0 doc - http://www.cisco.com/univercd/cc/td/doc/produc...

Hi All,Could you tell me how to configure PIX 501 to make vioce and video conversation via MSN Messenger and Netmeeting?Thanks in advance

Hi everyoneI am doing some research on Broadband Sevice Manager.Does BBSM support HP 5300 switches with VLAN's per port "protected port"?If a user has 'always dial my default connection' set, can they get internet access through BBSM without changing...

Hi!Long ago, in 1999, somebody pointed out that "selling routers with no CRLsupport is like selling a car with no brakes".Has it been changed since 1999? What do we have now?We are still waiting for good documentation from cisco, waiting for support(...

Hi,Is it possible to establish GRE\IP (no IPSec) between a Cisco IOS router and PIX ? Is there any document i can refer to ?Regards \\ Naman

Hey all,I know that this is a hard and broad question to answer, but I am trying to think of something to tell my client other than "uhh..I don't know". My PIX 515 recently "locked" up, leaving all of my hosting clients down. I was unable to ping the...

How long will a secondary PIX in a failover bundle pass traffic while the primary is down? Will it timeout?Thanks,RJ

1. After alert events are pruned into the fold "AlertPruneData", they will become some "txt" files. Which application can I use to read the events from these txt file?2. For the default alarm pruning, it is stated in the document only the events in t...

is there a command to show the free memory of a Pix (where store the pix configuration)?Thanks

Hi, I have cisco pix 515 with three interface cards. I have configured one as outside and the other as inside and i am hosting all my webservers,mail servers in the inside network. The internal interface card is connected to Cisco 3640 Router and the...

I have a VPN3000 (ver 3.5) at the hub site with PIX 501's deployed remotely. Remote sites can ping the hub site but not another remote site. I have enabled RRI (but not RIP or OSPF) on the VPN3000 and see the routes in the routing table. Pings timeou...