12-21-2022 01:46 AM - edited 12-21-2022 02:05 AM
Hello
I have a configuration HA FW ASA5525 CLI and i want to paste this configuration to HA FW 4112 CISCO.
Problem : my question :
I make the HA cablage connection for two FW 4112 and then I copy this configuration CLI or i copy configuration CLI to FW1 then FW2 then i do connection cabalge HA . ??
second question :
i want to access via interface web 4112 but i can't ??
FPR-4112-LAN-CNBB(local-mgmt)# show mgmt-port
eth0 Link encap:Ethernet HWaddr ac:bc:d9:59:bd:79
inet addr:10.10.10.12 Bcast:10.10.10.255 Mask:255.255.255.0
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
i wait a reply from expert security cisco
thanks in adv
12-21-2022 02:00 AM
also i have version in 4112 cisci
show version
Version: 2.8(1.129)
Startup-Vers: 2.8(1.129)
12-21-2022 11:05 AM
First, you are showing the chassis address and information, not the FTD device.
Second, converting an ASA configuration to FTD requires using a migration tool and FMC management server. There is no way to "paste" a configuration for FTD.
12-22-2022 12:16 AM
Hi @Dhikra Marghli,
Seeing you other thread, I understood you are looking into reimaging from FTD to ASA. How to reimage it - it is handled under other post.
Once you reimage device, and you are able to configure running ASA (you configured interfaces on ASA, you deployed instance, ASA is licensed), yes, you can copy ASA5525 CLI configuration to new ASA on FPR4100.
Kind regards,
Milos
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide