paste this configuration to HA FW 4112 CISCO

[Dhikra Marghli]

Hello

I  have a configuration HA  FW ASA5525  CLI  and i want to paste this configuration to HA FW 4112 CISCO.

Problem :  my question :

I make the HA cablage  connection for two FW 4112 and then I copy this configuration CLI  or  i copy configuration CLI to FW1  then FW2 then i do connection cabalge HA . ?? 

second question :

i want to access via interface web 4112 but i can't ??

FPR-4112-LAN-CNBB(local-mgmt)# show mgmt-port
eth0 Link encap:Ethernet HWaddr ac:bc:d9:59:bd:79
inet addr:10.10.10.12 Bcast:10.10.10.255 Mask:255.255.255.0
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)

i wait a reply  from expert security  cisco 

thanks in adv

[Dhikra Marghli]

also i have version in 4112 cisci

show version
Version: 2.8(1.129)
Startup-Vers: 2.8(1.129)

[Marvin Rhoads]

First, you are showing the chassis address and information, not the FTD device.

Second, converting an ASA configuration to FTD requires using a migration tool and FMC management server. There is no way to "paste" a configuration for FTD.

[Milos_Jovanovic]

Hi @Dhikra Marghli,

Seeing you other thread, I understood you are looking into reimaging from FTD to ASA. How to reimage it - it is handled under other post.

Once you reimage device, and you are able to configure running ASA (you configured interfaces on ASA, you deployed instance, ASA is licensed), yes, you can copy ASA5525 CLI configuration to new ASA on FPR4100.

Kind regards,

Milos