Hi, I am trying to ingest logs from Cisco Meraki MX to my SIEM and I'm getting more event types that the ones listed here: https://documentation.meraki.com/General_Administration/Monitoring_and_Reporting/Syslog_Event_Types_and_Log_SamplesWould you mi...
Forum Posts
Hi,Please walk me through how to block websites such as Facebook, YouTube or any adult contents. I have firewall 1100. Thanks Ammar
Hi All; May I know, What is the procedure for migrating the old firepower model to the new firepower model? scenario: Firepower ASA5506X managed by FMC needs to migrate to 1010 or another model
HI,We have been trying to make this work and so far not successful.We can get the metadata from the SAML group , but when SAML idp authenticates, the vpn anyconnect client comes back to the login window with a login failed. on the Debug we see no pro...
Resolved! Porting config - FMC to FortiVM
Hi,From what I've gathered there's approximately no way of exporting the config of the FMC other than the ACLs which I got using the below option:http://archive.dependencyhell.net/2017-07-09-dumping-firepower-acp/So since there's no easy way of getti...
Hi, I want to know if any or both of the Failover or state link between firewall failed which is required for HA configuration, which firewall will be active, How we can come to know that HA link between firewalls goes break to take the corrective ac...
Resolved! Delete Configuration off FMC
If there a way to delete a loaded configuration of the FMC. I just uploaded a configuration taken from a FMC and loaded it on a new one. Now i want to get rid of it. Any ideas?Thank you
Please what is the FTDv default username and password in AWS?I did not set any username or password while lunching.Thank you for the help.
Hi All,May i know if there is any way we can get the access to M365 using Dynamic list or any External Distribution List(Like Palo Does) in Cisco FTD?Regards,Sanjay S
Hi, Do we need to have the same type of interface for FPR-2110 HA Active/Standby configuration to core switches? For example, From FW 1, we have fibre connection to core switch A and from FW 2, we have copper connection to core switch B. will HA work...
Hi Community! I have a Firepower 1000 series. We have two public IP pools asigned by our ISP (2x /29). There is only one cable connected directly between the ISP router and our FirePower outside interface. Using one IP from one of the pools (firs...
Resolved! Cisco ASA and Firepower - GeoFiltering
Hello Experts, I had Russia blocked as GeoFilter in Firepower and policy is deployed successfully. When I run Packet-tracer command, it showed allow. Is it normal ? Or my Firepower policy is not in place? Thanks,
Hi All,We had cyber attach due to which my vASA and backup conf of ASA lost for immediate requirement vASA is configured again however with no rules it it and all traffic are allowed.What will be the best way to conf the vASA on the base of logging. ...
Hi Folks,In our data center vulnerability scanning from outside we are getting these two infections. we have two FWSM one at the internet gateway and the other internal FWSM. Now the management wants me to trace the source of this infection and stop ...
When using the FTD migration tool we have inside and outside in ASA, when i create the zones in the tool it does populate the source zone as INSIDE, however destination zone is ANY.Why doesn't the tool assign the rules to the correct OUTSIDE zone?I h...
