Hi Smith,
Can you try like the below for your requirement?
Examples
The following example shows the use of static interface NAT with port translation. Hosts on the outside access an FTP server on the inside by connecting to the outside interface IP address with destination port 65000 through 65004. The traffic is untranslated to the internal FTP server at 192.168.10.100:6500 through :65004. Note that you specify the source port range in the service object (and not the destination port) because you want to translate the source address and port as identified in the command; the destination port is "any." Because static NAT is bidirectional, "source" and "destination" refers primarily to the command keywords; the actual source and destination address and port in a packet depends on which host sent the packet. In this example, connections are originated from outside to inside, so the "source" address and port of the FTP server is actually the destination address and port in the originating packet.
hostname(config)# object service FTP_PASV_PORT_RANGE
hostname(config-service-object)# service tcp source range 65000 65004
hostname(config)# object network HOST_FTP_SERVER
hostname(config-network-object)# host 192.168.10.100
hostname(config)# nat (inside,outside) source static HOST_FTP_SERVER interface service FTP_PASV_PORT_RANGE FTP_PASV_PORT_RANGE
Make sure that you use a different object name for every translation you use for individual port wise
Server 1 TCP: 22, 5222, 8080, 8443-8444
UDP: 5222, 8080, 8444
Server 2 TCP: 80, 1710-1730, 6060-6070
UDP: 80, 6060-6070, 45000-64000
So you need to create 13 different object for the real address of servers..... server1 and 2 in total....
service object also needed for port range....
Regards
Karthik
