PDM location on PIX

[Paul.Lane]

I upgraded our PIX 515 from 5.3(4) to 6.2(2). I want to allow only certain workstations to access the FW with the PDM. However there are more than just the 2 workstations I wanted. I went down the list and did a no "followed by the command and ip" and got rid of them all. I did a write memory and when I checked the config again, they were back. How can I make it so that only the 2 workstations I specify can access the PIX with the PDM.

Thanks

[mostiguy]

http 1.2.3.4 255.255.255.255 inside

http 1.2.3.5 255.255.255.255 inside

will enable it for just those two hosts. There is no way to enable a subnet of IPs, and then selectively disable them with the no command - you need to enable only hosts and subnets you want access for.

[Paul.Lane]

Thanks!