PIX 501 Resetting after tunnel established

[c.whorton]

Running 6.3(3)122 on pix and 12.2(8)T on 1721

Pix is at home on SBC

DSL and 1721 is @ office on SBC DSL

Anyone tell me why PIX might be resetting?

Or tell me what logging option to use?

Chris

[sachinraja]

hi whorton,

is your pix resetting after ipsec tunnel establisment ? just check the cpu usage of the pix .. is it going too high ? you can enable debugging or informational logging. on the pix enable "logging host inside x.x.x.x" & "logging trap debugging" global commands and put the syslog servers ip address ...

see if you get any message from this server.you can refer to the below document for more information:

http://www.cisco.com/en/US/products/sw/secursw/ps2120/products_system_message_guide_chapter09186a00801582b1.html#wp1020115

All the best.. rate replies if found useful..

Raj

[c.whorton]

I found a new software version in the download 6.3(4) which I installed...am in waiting mode now to see if it will reset again...

I will let you know as soon as I hear from that site