07-16-2015 06:40 PM - edited 03-11-2019 11:16 PM
Hi, all
Has anyone used the PIX 515 with PIX Security Appliance Software Version 7.2(1)?
It seems not to accept the command ip address for ethernet interface when I am in the config-int mode.
After that, I go into the monitor mode and upgrade the IOS. But it still can't assign ip address in the config-int mode.
Does anyone encounter the same problem? Thanks.
Solved! Go to Solution.
07-17-2015 12:03 AM
Your ASA seems to be in multiple config mode. There the interfaces are configured differently. Try to switch back with the "mode" command.
07-17-2015 12:03 AM
Your ASA seems to be in multiple config mode. There the interfaces are configured differently. Try to switch back with the "mode" command.
09-16-2015 01:55 AM
Thanks for Karsten, I think the PIX 515's software version is too old.
Anyway, when I change the mode form multiple to single, it work.
07-18-2015 05:26 AM
Please attach configuration
Regards,
Puneesh
Please rate helpful posts
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide