Re: PIX 515 upgrade from 5.2.3 to 6.1.4 DMZ interface lost

m.mohamedmohideen · ‎11-02-2002

I did an upgrade from PIX 5.2.3 to 6.1.4 and when rebooted ethernet2 interface was not recognised. Show Interface does not list the ethernet2 (DMZ)

interface.

I put back the 5.2.3 and show interface displays the ehternet2 interface and everything is fine.

What is the problem I am facing?

I tried 6.2.2 version as well and ethernet2 still does not get recognised.

The Ethernet2 interface is purchased from Cisco.

Thanks.

jlimbo · ‎11-03-2002

Do you see any error when you boot up? Something with regard to "ignoring PCI card"?

-Jonathan

m.mohamedmohideen · ‎11-04-2002

No I did not see any ignoring PCI card message. Thanks

m.mohamedmohideen · ‎11-05-2002

Sorry for the previous reply.

I did the upgrade again and still I have the ethernet2 (DMZ) interface missing.

I can see the message "Ignoring PCI card in slot:2

Thanks

Nairi Adamian · ‎11-05-2002

There is field notice for this:

You need to open a TAC case.

hope this helps,

-Nairi