I try to configure my PIX515E (version 6.3.2) with a PIX Device Manager (version 3.0.1). I've got already a configuration (from an other PIX-PIX515 version 6.3.2), so I want to configure my new PIX as the old one, but with the PDM.And I've got some problems:
-PDM ignores some commands:
fixup protocol dns maximum-length 512
fixup protocol tftp 69
access-list NoNat permit ip host 10.147.333.31 host 192.168.10.20
and all my access-list command !!!
So where's the problem ?!
-I've got an other problem, a strange one.
When I use this command (nat (inside) 1 10.147.333.0 255.255.255.0 0 0) with the telnet configuration, there's no problem, when I refresh the PDM with the running configuration, it's good too, I see it in "Transaltion Rules", but when I wan't to use the same command with the PDM, it's impossible, I've got a problem with the "address pool", I can only choose "same adress". So I don't understand why ...
I hope you understand me, I'm a newbie with PIX and VPN ...
Thanks a lot for your help !!
and more ....
