PIX 515R PDM ACCESS ON OUT SIDE INTERFACE

[agnihotrir]

Greeting to all ,

Can any one give me config for PDM access to one specific ip address out side interface of firewall

[gfullage]

Run the "setup" command to establish the public/private key pair and it'll also ask you for the location of the machine running PDM. Enter in this IP address.

If that doesn't work, then the command is simply:

> http server enable

> http x.x.x.x 255.255.255.255 outside

where x.x.x.x is the outside machine's IP address

[ddicky]

great,but if i'm a teleworker conneting using VPN client and hooking up to the internet with fixed IP address.what is the config

[gfullage]

Then you need to connect ot the inside interface of the PIX, so upgrade it to 6.3 and use the following command:

> management-access inside

Then allow the VPN pool of addresses to http to the inside interface, should get you going.

See http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_sw/v_63/cmdref/mr.htm#1137951 for details of the new command.