03-26-2010 12:12 PM - edited 03-11-2019 10:26 AM
We just purchased a refurbished Pix 535 with ver 7.2(4) as a temp. solution until a backorderd ASA5550 arrives.
The Pix 535 will replace our existing Pix 525, which has ver 6.3(4).
I've read through some of the config. coversion documention concerning Interfaces and Fixup protocols.
Our Pix 525 has a very basic config. We don't do NAT and only have an access-list configured for our Outside interface.
Concerning the NAT. Will the following statements work on version 7.2(4). We still do not want to perform any NAT.
nat (inside) 0 155.42.0.0 255.255.0.0 0 0
static (inside,outside) 155.42.0.0 155.42.0.0 netmask 255.255.0.0 0 0
Thanks,
Tom
Solved! Go to Solution.
03-26-2010 12:41 PM
tffmaguire wrote:
We just purchased a refurbished Pix 535 with ver 7.2(4) as a temp. solution until a backorderd ASA5550 arrives.
The Pix 535 will replace our existing Pix 525, which has ver 6.3(4).
I've read through some of the config. coversion documention concerning Interfaces and Fixup protocols.
Our Pix 525 has a very basic config. We don't do NAT and only have an access-list configured for our Outside interface.
Concerning the NAT. Will the following statements work on version 7.2(4). We still do not want to perform any NAT.
nat (inside) 0 155.42.0.0 255.255.0.0 0 0
static (inside,outside) 155.42.0.0 155.42.0.0 netmask 255.255.0.0 0 0
Thanks,
Tom
Tom
Yes those commands will work on v7.2(4) although they seem to be doing the same thing.
Jon
Cisco are currently donating money to the Haiti earthquake appeal for every rating so please consider rating all helpful posts.
03-26-2010 12:41 PM
tffmaguire wrote:
We just purchased a refurbished Pix 535 with ver 7.2(4) as a temp. solution until a backorderd ASA5550 arrives.
The Pix 535 will replace our existing Pix 525, which has ver 6.3(4).
I've read through some of the config. coversion documention concerning Interfaces and Fixup protocols.
Our Pix 525 has a very basic config. We don't do NAT and only have an access-list configured for our Outside interface.
Concerning the NAT. Will the following statements work on version 7.2(4). We still do not want to perform any NAT.
nat (inside) 0 155.42.0.0 255.255.0.0 0 0
static (inside,outside) 155.42.0.0 155.42.0.0 netmask 255.255.0.0 0 0
Thanks,
Tom
Tom
Yes those commands will work on v7.2(4) although they seem to be doing the same thing.
Jon
Cisco are currently donating money to the Haiti earthquake appeal for every rating so please consider rating all helpful posts.
03-26-2010 01:16 PM
Thanks Jon.
I haven't work on a firewall in a couple of years, so I wanted to make sure the migration went smoothly.
I always get confused around the NAT syntax.
Again, I appreciate your quick response.
Thanks,
Tom
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide