06-07-2006 08:00 PM - edited 02-21-2020 12:57 AM
Hi,
I have pix 506e runnig as my Gateway Firewall.
Suddenly i am not able to Ping any interface,not able to telnet internal Interface.
Internet Browsing also stopped .
Can anyone plz tell me the causesa nd remedies for this.
I dont have any Syslog Server enable.
No one has done any changes in Configuration.
Thanks in advance.
Chetan
06-07-2006 10:53 PM
Hi, Chetan
you must access from console in firewall, check its internal interface status, its down, i suppose there is a problem that connection via switch or hardware problem on internal interface
Could you check first,
Ümit
06-08-2006 12:31 AM
Thanks,
I checked everytihng.
Nothing is appearing in Console.
Light Status on PIX.
Network (UP) Blinking
ACT (DOWN) Not Blinking
Power (UP) Stable Green Light
I think there is anything related to hardware failure
What do you all say?
Thanks
Chetan
06-08-2006 01:46 AM
Again Hi, Chetan
is there any switch between FW and LAN,its yes, check switch please,
you may be isolate switch,
Regards,
Ümit
06-08-2006 04:54 AM
Hi,
Yes there is switch in between. I replaced it and problem continues.
But now i m able to login through Console and Configuration is good and working,
Even i can ping outside/inside from pix, but after 2-3 minbutes PIX suddenly stops working and gives NILL response.
Does it has something related Config or I have to replace the BOX.
Thanks
Chetan kamra
06-08-2006 10:21 PM
Hi, Chetan
Could you check enviromental system (power outlet, voltage, ground, cable, module...vs) and isolate PIX from another connection (switch, router,pc...vs) and monitor status
Then you may enter factory default, check again.
Regards,
Umit
06-08-2006 10:36 PM
Thanks,
I have done Factory Default.
Ans now thinking of reinstalling the PIX IOS
Cisco PIX Firewall Version 6.3(3)
how can i do that can yoy please help me in doing thsi ASAP.
06-08-2006 11:39 PM
Chetan,
i attached a sample ios upgrade file, you first need to set up a tftp server (from may be www.solarwind.net or .com) ,
Please rate,
Umit.
06-11-2006 09:32 PM
Thanks
But my PIX doesnt goes ahead after reboot.
It is stuck on One location.
I think it hangs when rebooted.
And stopped responding.
Through console also you can only see starting after 1-3 seconds console mesaages are also stopeed.
What can be the reseaon.
I had resto9re factory default on friday and after that it worked for 2 days now suddenly it stopped again
ACT light in sgain DOWN.
ONLY Power,network lights are UP.
Is there any way from whihc i willbe able to Load IOS again.
Thanks in advance
Chetan
06-11-2006 09:47 PM
Hi Chetan
i understand that PIX has no access,there is no any way from your site,load IOS,i recommend that you take this PIX in your Lab,There is an environment problem or PIX hardware problem.
All the Best,
Umit
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide