06-07-2006 07:59 PM - edited 02-21-2020 12:57 AM
Hi,
Ihaev pix 506e runnig as my Gateway Firewall.
Suddenly i am not able to Ping any interface,not able to telnet internal Interface.
Internet Browsing also stopped .
Can anyone plz tell me the causesa nd remedies for this.
I dont have any Syslog Server enable.
No one has done any changes in Configuration.
Thanks in advance.
Chetan
06-08-2006 02:48 AM
Hi,
Can you try to acecss it via console? This is your best way to check the firewall status when all communication totally unavailable.
It could be due to anything, i.e loose UTP cable, switch-port issue, PIX inside interface or internal problem, etc.
Once you're in, check the inside/internal interface status using "sh interface" command. Also, try to ping any internal/external host/server/switch IP connected to your PIX.
Other that that, are you connecting your PIX to any layer-3 switch/router? Since "No one has done any changes in Configuration", check the switch/router port and route statement (if any).
Check the LED status as well.
*Front Panel:
POWER - Green : The device is powered on.
POWER - Off: The device is powered off.
ACT - Flashing green : The software image has been loaded.
ACT - Off: The device is powered off.
NETWORK - Flashing green: One or more network interfaces are passing traffic.
NETWORK - Off: No network interfaces are passing traffic.
Rear Panel:
ACT - On : Network activity is present on the port.
ACT - Off: No network activity is present on the port.
LINK - On: Data is passing on the port.
LINK - Off: No data is passing on the port.
Rgds,
AK
06-08-2006 04:16 AM
I check ed everything .
PIX started by changing Power cable.
But suddenly after 2-3 minutes it stops responding
I tried pinging Inside interface but afetr 2-3 minutes it shows RTO.
Thanks
Chetan
06-10-2006 06:51 AM
What do you see from console (CLI)? Sh log?
Enable syslog to highest level:
pix(config)#logging buffer debugging
Then test the PIX connectivity again. Can you ping anywhere from PIX console?
BTW, when you say changing power cable, does it mean you changed/swapped the power cord?
Rgds,
AK
06-11-2006 07:19 PM
Thanks
But my PIX doesnt goes ahead after reboot.
It is stuck on One location.
I think it hangs when rebooted.
And stopped responding.
Through console also you can only see starting after 1-3 seconds console mesaages are also stopeed.
What can be the reseaon.
I had resto9re factory default on friday and after that it worked for 2 days now suddenly it stopped again
ACT light in sgain DOWN.
ONLY Power,network lights are UP.
Thanks in advance
Chetan
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide