Hello,
How can I get the PIX log to show a timestamp that shows the time and date.
I get a strange #. Below is my show clock and show log output.
thanks,
rrc
> PIX(config)# sh logg
> Syslog logging: enabled
> Facility: 20
> Timestamp logging: enabled
> Standby logging: disabled
> Console logging: disabled
> Monitor logging: disabled
> Buffer logging: level debugging, 29 messages
> logged
> Trap logging: disabled
> History logging: level informational, 25
> messages logged
> 199002: PIX startup completed. Beginning operation.
> 609001: Built local-host inside:10.1.1.10
> 305011: Built dynamic ICMP translation from
> inside:10.1.1.10/51204 to
> outside:172.17.63.210/0
> 305011: Built dynamic UDP translation from
> inside:10.1.1.10/1028 to
> outside:172.17.63.210/1024
> 302015: Built outbound UDP connection 0 for
> outside:172.17.63.209/3006
> (172.17.63.209/3006) to inside:10.1.1.10/1028
> (172.17.63.210/1024)
> 101003: (Secondary) Failover cable not connected
> (this unit)
> 302015: Built outbound UDP connection 1 for
> outside:10.0.0.2/3006
> (10.0.0.2/3006) to inside:10.1.1.10/1028
> (172.17.63.210/1024)
> 302015: Built outbound UDP connection 2 for
> outside:10.0.0.1/3006
> (10.0.0.1/3006) to inside:10.1.1.10/1028
> (172.17.63.210/1024)
> 302010: 3 in use, 3 most used
> 502103: User priv level changed: Uname: enable_1
> From: 1 To: 15
> 111008: User 'enable_1' executed the 'enable'
> command.
> 111009: User 'enable_15' executed cmd: show version
> 111007: Begin configuration: console reading from
> terminal
> 111008: User 'enable_15' executed the 'configure t'
> command.
> 111008: User 'enable_15' executed the 'http 10.1.1.0
> 255.255.255.0 inside'
> command.
> PIX(config)#
>
> PIX(config)# sh clock
> 11:22:53.865 UTC Fri Oct 4 2002
>
>
