Network Security

This seems like it SHOULD be a simple thing to do. Maybe I'm missing something obvious. After 9/11 we were forced to install another Internet access point at another location outside NYC. We basically duplicated what we had in NYC: Pix firewall on...

After upgrading the PIX 506 software to 6.11, and loading the PDM software (pdm-112.bin) I get an error: 'Not a PDM file'.Does someone has any idea how I get PDM on this PIX???(The PIX works OK with the 6.11 software)*PBY*

Hi ,I want that the IDS should apply an acl to PIX when it detects an attack.I have tested this and found that cspm(2.3.3i)says that it has applied the acl and also shows in the event viewer that the ip address is blocked.But when I see the access-li...

I have installed a third nic into my pix-520. Does the pix automatically recognize it? I tried the interface command, the results are below:interface ethernet2 autoCould not recognize hardware identifier "ethernet2"Boot messages are below:Rebooting...

Hello, Is it true that you cannot NAT the ip address used by an interface on the PIX like you can on a cisco router ? We can only get one IP address from our isp. Can we still use a pix and NAT with only one ip ? Thanks!

I configured three vlans on catalyst2950,between 2950 and cisco3620,there is a pix 515,So could I make all of three vlans go to internet?If there is pix,i can configure subinterface on router,but now,how can i do?

Hi,I hope someone can help me.....I have a question here....I have installed CSPM233i and I have activaed the IDS feature in the PIX..and I have servers in the inside network... Can CSPM 233i send alert such as email if there is an attack to the serv...

I have a frame relay network that comes into the hub router into corporate HQ. We have a large SAP implementation that is hosted at a 3rd party location. So, traffic flows from the Frame, into the inside interface of the Corporate PIX 515, out the dm...

Is it possible to block .scr and other extensions at the Pix 515. Do I need additional software? Any examples would be greatly appreciated.Thanks,RJ

I have a frame relay network that comes into the hub router into corporate HQ. We have a large SAP implementation that is hosted at a 3rd party location. So, traffic flows from the Frame, into the inside interface of the Corporate PIX 515, out the ...

Does anyone know when PPPoE support will be available for the Pix 501?

Can you connect an windows 2000 VPN server to a Pix 520 in a wan to wan connection?

My VPN client 3.0.1 does not even connect to the PIX506 v6.0(1) at Phase 1. The client log shows:SENDING>>>ISAKMP OAK AG(SA, KE, NON, ID, VID, VID, VID) to 193.130.x.y (i.e. PIX outside)It tries 3 retransmissions, then says:Exceeded 3 IKE SA negotiat...

I had a PIX 515 w/Inside(172.16.0.0),Outside & DMZ(192.168.105.0). One particular server located on DMZ network. This particular server only serve internal users (not for Internet).Can I set the server allow 172.16.0.0 users only & let internal users...

Unix print jobs that previously passed through firewall cease to hit print server. No changes to policies on PIX have been made and a completely open conduit has been created to print server. Unix host and print server can ping each other.