09-17-2005 09:46 AM - edited 02-21-2020 12:24 AM
i am wondering how to configure ospf interface md 5 authentication on a pix ver 6.3...
at the same time, is it posible to set the pix as DR without doing any config at any of its peers, only one the pix. If so, what do I do?
thanks in advance
09-17-2005 10:01 AM
routing interface interface_name
Subcommands to the routing interface command:
ospf authentication message-digest
ospf message-digest-key key-id md5 key
ospf priority number
09-17-2005 10:06 AM
thanks man.. this was exactly what I was looking for..
I have one more Q to this. If I want summarize some networks after they are redistributed from my lan to my dmz... what to do..
thanks againb
09-17-2005 10:24 AM
you can be able summarize intra-area routes through :
area area_id range address netmask
09-17-2005 10:41 AM
do you do this summarization in the ospf process where i am redistributin to since this should be after redistribution ?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: