02-03-2012 02:37 AM - edited 03-11-2019 03:23 PM
Hi
I have failover on PIX-515E, before some days my primary box gone faulty so i recived the new rma box, now i want to installed that box in network currently my network is running on secondary box.i have installed the required licences and also upgarde the IOS on RMA box. The box is in serial failover.
Please suggest me the steps for introducing the RMA (Primary) boc in the network. As i want RMA box should work as primary itself.
Solved! Go to Solution.
02-03-2012 03:12 AM
02-03-2012 02:46 AM
Just plug the new box to network; connect cables like what the old box had and follow the commands said in the above link.
Complete these steps in order to replace a failed unit with a new unit:
Run the no failover command on the primary unit.
The status of the secondary unit shows standby unit as not detected.
Unplug the primary unit, and connect the replacement primary unit.
Verify that the replacement unit runs the same software and ASDM version as the secondary unit.
Run these commands on the replacement unit:
ASA(config)#failover lan unit primary ASA(config)#failover lan interface failover Ethernet3 ASA(config)#failover interface ip failover 10.1.0.1 255.255.255.0 standby 10.1.0.2 ASA(config)#interface Ethernet3 ASA(config-if)#no shut ASA(config-if)#exit
Plug the replacement primary unit to the network, and run this command:
ASA(config)#failover
02-03-2012 03:00 AM
Hi
thanks for ur reply
But i have confiusion in that becoz i want to enable the serial based failover and i thing u given the command for lan base failover.
please give me command to enable serial base failover
02-03-2012 03:12 AM
Follow the steps under
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide