Network Security

Hi everybody, please  need your help;I have this  message  when I session into the module:***LICENSE NOTICE***There is no license key installed on the NM-IPS.The system will continue to operate with the currently installedsignature set.  A valid lice...

Hello,I have an issue with my firewall,each time i configured a trunk port in the firewall and connect a sw 2960S with a trunk port also, all the interfaces in the Firewall go down ( virutal intertaces, inside, outside , dmz) , also another switch 37...

Hi All,When I telnet to a cisco PIX/ASA, I would like to get into privilege 15 automatically after a successful login by typing admin/cisco. I configured the following commands on the PIX but it doesn't work as expected. I still need to type in the e...

I'm looking to migrate from the pix 525 to asa 5520. PIX version is 8.0(4) and ASA 5520 version is 8.2(5). Do I need to upgrade the PIX prior to migration? Also looking on detailed steps on the migration process itself. Thanks.                  

The ASA default inspection policy includes a number of well-known applications and is applied globally on the systemclass-map inspection_defaultmatch default-inspection-trafficpolicy-map type inspect dns preset_dns_mapparameters  message-length maxim...

Hi, I have an issue were thousands of connections on the ASA are marked with flags E, below is a visual of the connection. Any ideas what could cause this marking? Also, I can't grasp what the meaing of an outside back connection (ie flags E). Thanks...

Hi, I need to import a running ASA 8.2.1 remote-access vpn (IPSEC and svc) configuration into CSM 3.3sp1 without service impact.During the last import and deployment test, I noted a lot of variation mada by CSM and service stop due to ip pool name mi...

                   Hi All,,We are having some issues with OSPF interoperability between a FWSM and ASA 5540. Both devices are running OSPF - if a network outage occurrs in can take over an hour once the network has recovered for the OPSF neighbour to...

I'm at a total loss here. I am transitioning from a Microsoft ISA server to a Cisco ASA 5510. So far so good, until it comes to getting AAA functioning properly. I have a Microsoft IAS server that is functioning properly, however when I try to test i...

We have an ASA5510 and I am getting absolutely no response from the console port.  Not even a blip when I turn it on.  If I leave the compact flash in the internal bay, I get Green Power, Amber Status, Amber Active and Green VPN when I start it up.  ...

Hi,I have a setup where the Client Network is connected to a Firewall and it is being managed by the client. That firewall is connected to my Network also.As it is connected to my network also i don't have any control to view the Traffic hitting my n...