cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
964
Views
0
Helpful
5
Replies

PIX VPN tunnel changes from L2L to User

maryowen1
Level 1
Level 1

I have a Pix 515E running v7.2. I can configure a site-to-site VPN and it works. I configure the next and it swings from L2L to User and fails, sometimes it will start as L2L then after about 8hours it becomes User and fails. If I configure a third it comes up as either L2L or User. I had no problems with 6.3. Help please

5 Replies 5

ohanusi2000
Level 1
Level 1

sorry what do you mean by changing from l2l to user.

Is the username and pasword prompt/ Xauth

Regards

IKE Peer: 213.123.155.41

The tunnels are site-to-site and should be as follows.

Type : L2L Role : initiator

Rekey : no State MM_ACTIVE

2 IKE Peer: 213.123.166.33

Type : L2L Role : initiator

Rekey : no State : MM_ACTIVE

But every now and again the second tunnels changes to

IKE Peer: 213.123.166.33

Type : User Role : initiator

Rekey : no State : MM_WAIT_MSG2

and stops working

can you post a config?

Thsi is my config. I have added a cisco vpn client configuration, but it happens regardless of wether the client is configured or not

Hi,

Can not see anything wrong apart

tunnel-group-map default-group DefaultL2LGroup

This will make most connection look like site to site if it can not resolve the tunnel group that the connection belongs to .

May try upgrade .

Regards

Review Cisco Networking for a $25 gift card