Network Security

Hi,Would like to take access on ASA from the public network via ssh.What should be the config of my asa.Is there any command to connect to the my device as that we use telnet <ip address of the device>.How to access the device using device from clien...

Dear ALL,I'd like to know if is there a CISCO firewall able to perform layer application filtering task, like protection from cross site scripting and sql injections. Regards Alberto Brivio

Has anyone has any problems with the mounting brackets that they send with the ASA? I have a 5520 with one of those T looking bracets. When you install the devices facing the front, the part where it looks like a T extend beyond the device and doesn'...

One of my users can't access an e-library which is running on port 8080. how can I open this port for only this particular user...

Hi,I have an ASA5510. When I put the command 'crypto map MAP 20 set peer a.b.c.d', an error message "[IKEv1]: Ignoring msg to mark SA with specified coordinates <MAP, 20> dead" comes out. What does this mean?When I turned out debug crypto isakmp 127,...

Hi all Please let me know if we can configure TACACS for IDS .If yes , please let me know how to go about the same RegardsAnkur

So I have a L2L vpn tunnel up between a PIX 506E and a PIX 515EWhen i try to load https://pix-506E from user connected to PIX-515E i can't access to it.I believe i need to apply an ACL to PIX-506E to allow PIX-515E on port 8080.Can you pleae help me ...

OK, I am stumped. I created the VPN connection, have it auto xauth, VPN comes up, but I cant route. What do I need to do the get routing established? The networks I need to reach are 10.14.0.0/24, .1.0, .2.0, and .3.0 /24 which are behind the ASA, th...

Hello!I have some problems with CSA and Apache on RedHat Linux Enterprise ES 4. During the logrotate process CSA denies all connections to Apache and gives the alert such asMay 19 15:15:06 msks0080 CiscoSecurityAgent[3297]: Event: The process '<Unkno...

Hi, We have multiple ASA's (7.2) and installed on different locations and we have established VPN connection among all of them. Now we want to upgrade 8.3 version one by one on all location. After upgrading it is required new configuration or all con...

Im trying to do a password recovery on a PIX,i downloaded the password recovery software np63 and renamed it to np63.bini keep following these steps..monitor>interface 00: i8255X @ PCI(bus:0 dev:13 irq:10)1: i8255X @ PCI(bus:0 dev:14 irq:7 ) Using 0:...

Hi ,Iam facing problem in configuring IPS SSM in ASA 55201)Its not taking the ip on virtual sensing interface. 2)iam not able to ping the management ip address although the gateway is pingable.this is the show config of SSM Module.! -----------------...

Hi,While configuring the cable based failover, i selected one of the data interface to be also failover linkcommand i used was failover link interface2. The ip address is already assigned to interface 2. This was on the primary unit only. on the seco...