05-03-2022 09:45 PM
hi,
i'll be migrating power source to a new vertical PDU.
do i just remove the power cable on the ASA 5525-x or issue a 'reload' for a 'graceful' shutdown then remove power cable.
just want to ensure config will remain intact when power off/on the ASA.
05-03-2022 09:51 PM
you can just power off from power source. make sure configuration is saved before shutdown. and after connect new power source device will load saved config
05-04-2022 12:53 AM - edited 05-04-2022 09:28 PM
By the way there is no command to power off the ASA. Just make sure the config has been saved then power off with the on/off switch.
LiteBlue
05-04-2022 01:18 AM
If there's a Firepower service module active then it is best to shut it down gracefully if you have the chance.
The ASA software itself is fine to just recover from hard power off as long as the running-configuration was saved.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Log in to Community
