08-04-2009 10:08 AM - edited 03-11-2019 09:02 AM
Hi
In ASA 8.0,I have following queries related to redundant interfaces
a)While configuring redundant interface can the redundant interface again be divided into logical interface like red1.1 , red1.2 ?
b)Is Redundant interface supported in the Multiple context mode
Regards
Ankur
08-04-2009 01:15 PM
Yes Ankur,it is possible.
##snippet##
interface Ethernet0/0
shutdown
no nameif
no security-level
no ip address
!
interface Ethernet0/1
speed 100
nameif inside
security-level 100
ip address 192.168.16.19 255.255.255.128
ospf network point-to-point non-broadcast
ospf message-digest-key 123 md5
!
interface Ethernet0/2
shutdown
no nameif
no security-level
no ip address
!
interface Ethernet0/3
nameif null0
security-level 50
ip address 10.2.1.1 255.255.255.0
!
interface Management0/0
no nameif
security-level 0
no ip address
!
interface Redundant1
member-interface Ethernet0/0
member-interface Ethernet0/2
no nameif
no security-level
no ip address
!
interface Redundant1.1
vlan 32
no nameif
no security-level
ip address 1.1.1.8 255.0.0.0
Regards,
Sushil
08-06-2009 03:39 AM
Hi
thanx for the example .Hi can we configure red. interfaces in PIX and FWSM or only in ASA 5500 Series .
Also i wanted to know if the Redundant interface supported in the Multiple context mode
Ankur
08-07-2009 08:25 AM
Hi
Please guide me for my above query
Ankur
06-12-2012 01:22 AM
HI
Can anyone tell wheather I can use Interface redundancy concept for 1 nos of ASA to connect 2 nos of core switches(Act/Stanby). I have configured but only one interface of the ASA always active. What can be the issue.
Kantha
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide