Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
497
Views
0
Helpful
1
Replies

Reimaging IDSM2

chri5k
Level 1
Level 1

‎02-02-2006 01:41 PM - edited ‎03-10-2019 01:52 AM

I have a remote switch with an IDSM2 that is not functioning properly. I can connect to the module via SSH using the "service" account and get a Linux root shell. I have rebooted the sensor but no luck. Is there a way to restore the operating partition from the backup partition using the Linux command prompt?

Labels:
0 Helpful
1 Reply 1

smalkeric
Level 6
Level 6

‎02-08-2006 07:47 AM

Do not make modifications to the IDS module through the service account except under the direction of TAC. If you use the service account to configure the IDS module, your configuration is not supported by TAC. We do not support the addition and/or running of an additional service to the operating system through the service account, because it affects the proper performance and proper functioning of the other IDS services. TAC does not support an IDS module on which additional services have been added.

Telnet to the Catalyst 6500 series switch:

telnet ip address

session slot_numbe

login: cisco

Password: cisco

If you are logging in for the first time, you are prompted to change your password.

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card