RemoteAccess - PIX/VPNClient and netmask

[marcusl]

Hi,

I've realized that it is impossible to assign a subnetmask to a pool that is distributed to clients. From the information I've found - it should be possible using VPN3000. Does anyone know if IOS & PIX will get a fix for this issue?

It's actually not a really big issue since it's possible to assign another major net - however, it would make a lot of ip-plans look better... :-)

Best regards,

/M - CCDP & CCNP.

[jsivulka]

An enhancement request already exists. You could have a look at CSCdx13902.

You could also refer to http://www.cisco.com/en/US/products/sw/secursw/ps2308/products_administration_guide_chapter09186a008015cfda.html and http://www.cisco.com/en/US/products/sw/secursw/ps2308/products_administration_guide09186a00800bd98e.html#1171787

[marcusl]

Thank you for your reply.

However, that bug is specific to VPN3000 - I'm having the problem with PixOS/IOS ..........

What is the correct approach for a enhancement request? TAC case?

Best regards,

/M