cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
619
Views
0
Helpful
3
Replies

Required OID number to Monitoring Current host count

Haider Malik
Level 1
Level 1

Hello all .

I can get the current host count running below command .

sh local-host connection

Detected interface 'outside' as the Internet interface. Host limit applies to all other interfaces.

Current host count: 10, towards licensed host limit of: 50

I need the Device OID which holds that information under system MIB's  .

Kind Regards

1 Accepted Solution

Accepted Solutions

David White
Cisco Employee
Cisco Employee

Hi,

Unfortunately, the ASA does not have an OID for these stats.

Sincerely,

David.

View solution in original post

3 Replies 3

David White
Cisco Employee
Cisco Employee

Hi,

Unfortunately, the ASA does not have an OID for these stats.

Sincerely,

David.

Thank you is there any way i can check the same status on the ASDM ?

Unfortunately, no.  ASDM does not provide this capability natively.  You can use the CLI interface within ASDM, but I don't think that is what you were looking for.

Sincerely,


David.

Review Cisco Networking for a $25 gift card