Reset ASA Firepower on ASA 5506-X

[fs0000001111]

Hi,

I want reset to Factory Default on Cisco ASA 5506-X.

I try with ASDM, and console mode, but the ASA Firepower are always configure ( Licence Agree, Enable, and IP Configure)

How reset the firepower to factory Default?

[Marvin Rhoads]

What's your goal in doing so?

If you want to really take it back to zero configuration, you can always uninstall the FirePOWER module and re-image it from scratch. The ASA cli command to do that is:

sw-module module sfr uninstall

You would then have to reload both boot and system images to get it running again.

[fs0000001111]

I made a mistake in my testing, and arrives change this setting.
I would like to reset the ASA Firepower to start from scratch.

I'm going to try.

Thanks.

[Marvin Rhoads]

OK. If you do the uninstall, you will need to first make sure you have on hand the boot image (.img file) and install package (.pkg) files to re-install. Assuming you have entitlement to download, those can be found here:

https://software.cisco.com/download/release.html?mdfid=286283326&flowid=77251&softwareid=286277393&release=6.0.1.1&relind=AVAILABLE&rellifecycle=&reltype=latest

Complete installation instructions can be found here:

http://www.cisco.com/c/en/us/support/docs/security/asa-firepower-services/118644-configure-firepower-00.html#anc7

Please mark your question as answered if it has been.