Hi,My Cisco WAP 321 Access Point Does Not Start.The Power LED blinks slowly Green. Access point is available on network.No Wifi signal is present.I don't have Acces to recovery mode.How do I restore my access point?Best Regards.Fabrice.
Hi,
I want configure Dual ISP on ASA 5506-X (based license).
I tried this procedure (ASDM mode)
http://www.cisco.com/c/en/us/support/docs/security/asa-5500-x-series-next-generation-firewalls/118962-configure-asa-00.html
But it does not work. When ...
Hi,
I want reset to Factory Default on Cisco ASA 5506-X.
I try with ASDM, and console mode, but the ASA Firepower are always configure ( Licence Agree, Enable, and IP Configure)
How reset the firepower to factory Default?
Hi,
I have some problem with one Remote IPSEC Tunnel.
Since a few days, when I want connect my remote IPSEC Tunnel with VPN Client CISCO, the software try to connect, but never ask me the user name and password.
I tried to restart Modem and Firewall...
Hello,
I performed the Hard reset (30/30/30) of the access point, however, it is not available.
Network cable not connected, no ping response, Blinking green power light.
Yours.
Fabrice.
Hello Kristian,
I tried accessing it from my network, but it's not available.
I tried to perform a factory reset. After the "factory reset" (20s on the reset button) I try to connect the WAP directly to a laptop (With static IP 192.168.1.1) on ...
Hi,
attached the running config.
: Saved: : Serial Number: JAD202707BB: Hardware: ASA5506, 4096 MB RAM, CPU Atom C2000 series 1250 MHz, 1 CPU (4 cores): Written by enable_15 at 09:21:44.194 UTC Mon Oct 24 2016!ASA Version 9.6(1) !hostname ciscoasa...
I made a mistake in my testing, and arrives change this setting.I would like to reset the ASA Firepower to start from scratch.
I'm going to try.
Thanks.
Yes, this was working and now it is not.
I made no update, modification, ...
I have configure one port forwarding for try one RDP access, it's work perfectly.
I have many VPN site-to-site configure and it's work.