cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3318
Views
0
Helpful
4
Replies

Routes not showing in Routing Table - ASA 5512

GRANT3779
Spotlight
Spotlight

I have just upgraded ASA image to 9.5.1 and notice that nothing shows in the routing table even though I have statics. Other ASAs I have on previous versions seem to be showing my statics.  Routing from the ASA seems to be OK though. If I add a new static pointing it out the LAN interface it appears in the routing table. Just doesn't seem to show the ones pointing out the MGMT on 9.5.1


sh run route

route MGMT 10.44.128.0 255.255.240.0 172.28.37.1 1
route MGMT 10.44.142.0 255.255.255.0 172.28.37.1 1
route MGMT 10.44.144.0 255.255.240.0 172.28.37.1 1

sh route

Codes: L - local, C - connected, S - static, R - RIP, M - mobile, B - BGP
D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2
i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2
ia - IS-IS inter area, * - candidate default, U - per-user static route
o - ODR, P - periodic downloaded static route, + - replicated route
Gateway of last resort is not set


sh route static

Codes: L - local, C - connected, S - static, R - RIP, M - mobile, B - BGP
D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2
i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2
ia - IS-IS inter area, * - candidate default, U - per-user static route
o - ODR, P - periodic downloaded static route, + - replicated route
Gateway of last resort is not set


sh route MGMT

Codes: L - local, C - connected, S - static, R - RIP, M - mobile, B - BGP
D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2
i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2
ia - IS-IS inter area, * - candidate default, U - per-user static route
o - ODR, P - periodic downloaded static route, + - replicated route
Gateway of last resort is not set

1 Accepted Solution

Accepted Solutions

Hi Grant,

Do you see any entry under :

show route management-only 

Regards,

Aditya

Please rate helpful posts.

View solution in original post

4 Replies 4

Dinesh Moudgil
Cisco Employee
Cisco Employee

Hi 

Cisco Network Security Channel - https://www.youtube.com/c/CiscoNetSec/

sh inte ip bri

Interface IP-Address OK? Method Status Protocol
GigabitEthernet0/0 10.99.3.8 YES unset up up
GigabitEthernet0/1 10.99.3.8 YES unset up up
GigabitEthernet0/2 unassigned YES unset administratively down down
GigabitEthernet0/3 unassigned YES unset administratively down down
GigabitEthernet0/4 unassigned YES unset administratively down down
GigabitEthernet0/5 unassigned YES unset administratively down down
Internal-Control0/0 127.0.1.1 YES unset up up
Internal-Data0/0 unassigned YES unset up up
Internal-Data0/1 unassigned YES unset up up
Internal-Data0/2 unassigned YES unset up up
Management0/0 172.28.37.2 YES unset up up
BVI1 10.99.3.8 YES CONFIG up up

This ASA is in transparent mode, but so are my others which sh a routing table. I believe in transparent mode it will perform route lookup when traffic originates from ASA, e.g syslog.

Hi Grant,

Do you see any entry under :

show route management-only 

Regards,

Aditya

Please rate helpful posts.

Hi Aditya,

That works. The routing table is visible. Does anyone know why this has changed in the different code?

Thanks

Review Cisco Networking for a $25 gift card