Save configuration in ASA 5505

[adavila03]

Hi all,  I have this issue, I save the configuration in the ASA 5505 using write memory or using copy run start but whe i unplug the power cord and plug it back in the ASA gets its factory default configuration.... then what i do is a copy start run to get the configuration active....

why is this so? even though i saved the config to flash ... regards!

[Eugene Khabarov · Accepted solution]

You have incorrect boot register:

Please follow up the following document:

http://www.cisco.com/en/US/docs/security/asa/asa71/configuration/guide/trouble.html#wp1062992

You need to set up default value 0x1

___

HTH. Please rate this post if it was helpful. If this solves your problem, please mark this post as "Correct Answer"

[adavila03]

I never changed the config register. the default value was 0x41 . I switched it back to 0x1.

Thanks for your response!