The pix "boots", but nothing appears on the Hyper Terminal, and the leads in the front don't
light up.
The leads light up half a second when I start and when I stop the pix...
When I close it, I have 4 little ASCII squares that appear on Hyper Terminal (this is
when I am not in not in the normal configuration of the Hyper Terminal)
To light up the leds, I have to put a USB cable in the USB port.
I am not sure, but I think that few days after I upgraded for the 6.2 IOS, I had a
"watch dog failure" and I was not able to reboot it.
The ram is tested and is ok.
I tried another PSU (the one of a 2611 and nothing happened)
I tried another CPU too, but it did not work.
I think it's the motherboard....
I dont have contract with Cisco...