Setting IP-Mac (manual) on Cisco Firepower 2110

[eeebbunee]

Hello Engineers,

I am using DHCPD from the Firepower (2110, ver:6.2.3.16) for the Guest network users.

 - Guest DHCP Pool: 192.168.1.0/24

so far, all of dhcp binding has automatic. However, I would like to make static IP-Mac address for some reasons.

On GUI, I found APR config from Physical Interface config, but I am not sure if I make static mac address and IP, it makes binding manually.

Can anyone tell me how to set manual binding?

I appreciate your comment!

[balaji.bandi]

If you looking to reserve some IP address to clients, on the pool you need to exclude that addresses. so there is no pool allocation for the user when the DHCP request come in, it only reserve for the MAC address .