sfr module interfaces not showing

[omera]

Hi,

The asa sfr module doesn't show any of the ASA interfaces when I open the interfaces tab on the FMC, the weird thing is that the interfaces are showing on the sfr module CLI when I execute show interfaces.

Both control and protection licesnese are installed.

The hardware is ASA 5525x running on version 9.8(2)

Firepower Extensible Operating System Version 2.2(2.52)

The Firepower module is running 6.4.0-102

Also tried to fix this issue with the workaround fix that cisco suggest on bug CSCut40770 even though this version isn't one the affected once.

sfr CLI output:

> show interfaces
--------------------[ outside ]---------------------
Physical Interface        : GigabitEthernet0/0
Type                      : ASA
Security Zone             : None
Status                    : Enabled
Load Balancing Mode       : N/A
---------------------[ inside ]---------------------
Physical Interface        : GigabitEthernet0/1
Type                      : ASA
Security Zone             : None
Status                    : Enabled
Load Balancing Mode       : N/A

[eruizrub · Accepted solution]

Hi dude,

Have you tried to synchronize the device on FMC ? on some occasions take time.

Or try to add again the module on FMC.

Regards.

[omera]

Worked like a charm, deleted the modules and added them again.

Thanks