08-28-2019 04:57 AM
Hi,
The asa sfr module doesn't show any of the ASA interfaces when I open the interfaces tab on the FMC, the weird thing is that the interfaces are showing on the sfr module CLI when I execute show interfaces.
Both control and protection licesnese are installed.
The hardware is ASA 5525x running on version 9.8(2)
Firepower Extensible Operating System Version 2.2(2.52)
The Firepower module is running 6.4.0-102
Also tried to fix this issue with the workaround fix that cisco suggest on bug CSCut40770 even though this version isn't one the affected once.
sfr CLI output:
> show interfaces --------------------[ outside ]--------------------- Physical Interface : GigabitEthernet0/0 Type : ASA Security Zone : None Status : Enabled Load Balancing Mode : N/A ---------------------[ inside ]--------------------- Physical Interface : GigabitEthernet0/1 Type : ASA Security Zone : None Status : Enabled Load Balancing Mode : N/A
Solved! Go to Solution.
08-28-2019 06:41 AM
Hi dude,
Have you tried to synchronize the device on FMC ? on some occasions take time.
Or try to add again the module on FMC.
Regards.
08-28-2019 06:41 AM
Hi dude,
Have you tried to synchronize the device on FMC ? on some occasions take time.
Or try to add again the module on FMC.
Regards.
08-28-2019 12:30 PM
Worked like a charm, deleted the modules and added them again.
Thanks
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: