01-15-2015 11:17 AM - edited 03-11-2019 10:21 PM
I'm setting up a new ASA 5505 and am stumped. I'm running 8.2(5) and can't figure out why my inside clients can't get to the Internet. I can get out from the outside interface but when I try to ping from the inside interface it fails. Along with all my LAN clients.
Config below:
83# sh run
: Saved
:
ASA Version 8.2(5)
!
hostname 83
names
!
interface Ethernet0/0
switchport access vlan 2
!
interface Ethernet0/1
!
interface Ethernet0/2
!
interface Ethernet0/3
!
interface Ethernet0/4
!
interface Ethernet0/5
!
interface Ethernet0/6
!
interface Ethernet0/7
!
interface Vlan1
nameif inside
security-level 100
ip address 192.168.6.1 255.255.255.0
!
interface Vlan2
nameif outside
security-level 0
ip address 1.1.1.3 255.255.255.248
!
ftp mode passive
pager lines 24
logging asdm informational
mtu inside 1500
mtu outside 1500
icmp unreachable rate-limit 1 burst-size 1
no asdm history enable
arp timeout 14400
global (outside) 1 interface
nat (inside) 1 0.0.0.0 0.0.0.0
route outside 0.0.0.0 0.0.0.0 1.1.1.1 1
timeout xlate 3:00:00
timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 icmp 0:00:02
timeout sunrpc 0:10:00 h323 0:05:00 h225 1:00:00 mgcp 0:05:00 mgcp-pat 0:05:00
timeout sip 0:30:00 sip_media 0:02:00 sip-invite 0:03:00 sip-disconnect 0:02:00
timeout sip-provisional-media 0:02:00 uauth 0:05:00 absolute
timeout tcp-proxy-reassembly 0:01:00
timeout floating-conn 0:00:00
dynamic-access-policy-record DfltAccessPolicy
http server enable
http 192.168.0.0 255.255.0.0 inside
no snmp-server location
no snmp-server contact
snmp-server enable traps snmp authentication linkup linkdown coldstart
crypto ipsec security-association lifetime seconds 28800
crypto ipsec security-association lifetime kilobytes 4608000
telnet timeout 5
ssh 10.1.10.0 255.255.255.0 inside
ssh 192.168.0.0 255.255.0.0 inside
ssh 70.91.136.0 255.255.255.0 outside
ssh timeout 5
console timeout 0
dhcpd dns 75.75.75.75 75.75.76.76
!
dhcpd address 192.168.6.5-192.168.6.132 inside
dhcpd enable inside
!
threat-detection basic-threat
threat-detection statistics access-list
no threat-detection statistics tcp-intercept
webvpn
!
class-map inspection_default
match default-inspection-traffic
!
!
policy-map type inspect dns preset_dns_map
parameters
message-length maximum client auto
message-length maximum 512
policy-map global_policy
class inspection_default
inspect dns preset_dns_map
inspect ftp
inspect h323 h225
inspect h323 ras
inspect rsh
inspect rtsp
inspect esmtp
inspect sqlnet
inspect skinny
inspect sunrpc
inspect xdmcp
inspect sip
inspect netbios
inspect tftp
inspect ip-options
!
service-policy global_policy global
prompt hostname context
no call-home reporting anonymous
Cryptochecksum:d41d8cd98f00b204e9800998ecf8427e
: end
01-15-2015 11:24 AM
Duh. Nevermind.
policy-map global_policy
class inspection_default
inspect icmp
01-17-2015 05:53 AM
Hi,
You can also try this sweet and small command:-
fixup protocol icmp
Thanks and Regards,
Vibhor Amrodia
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide