What is Difference between firewall and UTM appliance
Forum Posts
How do I get SW1 and SW2 to be pingable on the ASA?1. Redundant interface should not be used. Because the real product is Firepower. Firepower does not support redundant interface.2. I want the ASA to have one IP. So I used BVI interface and bridge ...
Configuring ASR 1001-x to use LDAP. what is interesting is that I add the servers, two, and the config shows up as being configured. When I next add the servers to a group, "aaa group server ldap LdapGrp". it will return ok. Next in the ldap server g...
Hi everyone, I'm having a hard time understanding why my ASA shows I have the 3DES-AES encryption disabled. I have a security plus license on this device. Furthermore, I have already requested a free encryption license through the licensing portal. ...
Hi everyone,I successfully configured Cisco FPR1010. Unfortunetly now I can not connect to FXOS. FPR1010 boot directly to ASA code and when I want to connect from ASA CLI to FXOS i get that error.The details you can see below. Can you give an advice ...
Resolved! Missing tab in Summary Dashboard of FMC
Hello, I noticed that in Summary Dashboard of FMC, is not anymore available the Network tab.(Most probably it has been accidentally deleted) Do you know if i can restore only this tab in the dashboard or i have to restore the FMC configuration back...
What is the proper ACL to block internet on one server using an ASA 5545 version 9.6(4) 20?
Resolved! Enable SNMP v2 on FTD 1010 using FDM
Hello,We use SNMP v2 through solarwinds for remotely monitoring our devices. We have a Cisco FTD 1010 we are deploying to a site using FDM. I understand you can use flexconfig to enable this, but I'm having some troubles. I verified I have access rul...
After doing some tests with clogin, the configuration of the interfaces had been changed.From ospf message-digest-key 3 md5 W@tytl#3459Qaz -->> ospf message-digest-key 3 md5 *****From! - before clogin tests interface GigabitEthernet0/1.128 vlan 1...
Hello @balaji.bandi @Rob Ingram @Marvin Rhoads @Mohammed al Baqari @Richard Burts @Aref Alsouqi @Richard Burts @Joseph W. Doherty @Giuseppe Larosa I got Cisco ASA 5525 with Firepower services and got FMV VM to manage the Firepower service...
Hello,Please I am tasked with migrating 3 different ASAs into Firepower, I am trying to use the migration tool which seems faster but my problem is each time I connect the migration tool to each ASA, a new policy package is generated hence this will ...
Hi, I have 5506-X with Firepower services, Do i need the URL license for Whitelisting URLs or it just be needed in case i need to blacklisting (Block) urls?The purpose for this that i have a network which i just need to permit a specific URLs and blo...
My 3rd party cert expired on my ISE and I got another. I am just having a terrible time figuring out how to get it in and if I even have the correct type of cert
Resolved! FMC/FTD NAT
HiDoes anyone have any suggestions on why I am getting NAT failures on FTD I have configured a rule allowing WLC inside to outside on ports 16666/16667 and ETHIP(97) the WLC is part of a NAT rule Natting all rfc1918 to an address.??? Thanks
Hello, I've noticed that I cant create vlan interfaces on this model but I use to be able to on older model like the ASA5505. Has this been changed ? I'm new to the X series. what's the equivalent of doing this on the 5555-X ?
