snmp configuration

[elite2010]

Hi,

I am trying to configure snmp for asa . 

my snmp server ip is 10.0.0.1 ,

In syslog i am getting the following message "refused connect from 10.0.0.1"

ASA(config)# snmp-server enable
ASA(config)# snmp-server host inside 10.0.0.1  community somesecretword
ASA(config)# snmp-server community somesecretword
ASA(config)# snmp-server enable traps snmp authentication linkup linkdown coldstart

inside intereface there is no policy , I can reach the the server from the asa  .

Please help 

[GRANT3779]

What version of SNMP are you using on the ASA as it didn't seem to be manually configured looking above. 2c potentially by default. Does it match on 10.0.0.1?
You can check ASA using

show snmp-server host

[elite2010]

Hi,

the output shows 

host ip = 10.0.0.1, interface = inside  trap community ***** version 2c

Thanks

[GRANT3779]

Hi,

I'm not sure if you only have traps enabled looking at that output. Are you looking to poll from your SNMP Server?

I would try removing the following initially for testing -

 snmp-server enable traps snmp authentication linkup linkdown coldstart

Keep the rest of the config you have.

What are you using for your SNMP server, I assume it is configured with appropriate version and passwords etc.. I would assume so.