SNMP monitoring of virtual FMC

[jmandersson]

Hi Community,

I'm trying to add my newly installed FMC Virtual (VMWare) to our monitoring system (LibreNMS) with no luck. I have followed this guide and tried with both SNMP v3 and SNMP v2C. The access list has been  configured, tried with both a specific host and a "permit any SNMP".

If a run a TCP Dump on the FMC I see that the SNMP queries are recieved but the V3 queries are responded with :

snmpUsmMIB.usmMIBObjects.usmStats.usmStatsUnknownEngineIDs.0=28 

snmpUsmMIB.usmMIBObjects.usmStats.usmStatsUnknownUserNames.0=26

V2c queries are not responded at all.

Has anybody an idea of what is wrong?

Best regards,

Johan

[Marvin Rhoads]

If you're still struggling with this issue, please see the following thread:

https://community.cisco.com/t5/network-security/fp-diagnostic-interface-setting-up/m-p/4032998#M943543