cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
870
Views
2
Helpful
3
Replies

SNMP sever on Firepower managed by FDM

janvanek
Level 1
Level 1

Hello community!

I'm struggling with setting up a snmp server on a cisco FTD. I only have on-box management (FDM) running with the suggested version 7.2.5.

I'm pretty sure that in the past it was possible to upload the configuration via flexconfig, but now the flex config policy tells me that the command "snmp-server" is deprecated. I just need to monitor the device from external Zabbix server. Is there any workaround how to enable  SNMP server here?

Thank you all

Jan

1 Accepted Solution

Accepted Solutions

@janvanek unfortunately, you still cannot configure SNMP natively in the FDM GUI, you configure SNMP on FDM using RestAPI.

https://www.cisco.com/c/en/us/support/docs/security/firepower-ngfw/216551-configure-and-troubleshoot-snmp-on-firep.html

 

View solution in original post

3 Replies 3

@janvanek unfortunately, you still cannot configure SNMP natively in the FDM GUI, you configure SNMP on FDM using RestAPI.

https://www.cisco.com/c/en/us/support/docs/security/firepower-ngfw/216551-configure-and-troubleshoot-snmp-on-firep.html

 

janvanek
Level 1
Level 1

Hi Rob, thx. for your reply. This is the solution. A little pity that Cisco removed the super easy snmp-server configuration, but what we can do...

Sudqi
Level 1
Level 1

Hello everybody,

I see that the MGMT interface is not allowed to be as a source in the SNMP configuration, but does anyone know if the tunnel interface also the same?

Review Cisco Networking for a $25 gift card