cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3739
Views
0
Helpful
1
Replies

SNMP TRAPS configuration on FTD and FMC.

bmak
Level 1
Level 1

Hi,

 

I am trying to configure the following SNMP traps on my FTD and FMC devices

 

Traps;

Environment traps; Power supply failure, Critical CPU temperature, Fan failure

Resource traps; Memory threshold reached

Cpu Utilization traps; Cpu Rising threshold reached

 

I am able to configure these on a standalone ASA via ASDM just fine, but I do not see the option to have them configured on the FMC.

On carrying out a search about this online, I see I can make use of "Alarms" and then redirect the alarms to the SNMP server.

I will like to know if there is a way to set these monitoring parameters via SNMP traps on the FMC as is done on the ASDM, rather than make use of alarms.

 

Thank you

 

1 Reply 1

Francesco Molino
VIP Alumni
VIP Alumni
Hi

Have you tried this configuration guide:
https://www.cisco.com/c/en/us/support/docs/ip/simple-network-management-protocol-snmp/213971-configure-snmp-on-firepower-ngfw-applian.html#anc21

Thanks
Francesco
PS: Please don't forget to rate and select as validated answer if this answered your question
Review Cisco Networking for a $25 gift card