Solarwinds monitor configuration

[chpmotry]

hi guys.

I'm running SolarWinds server in my network . and I configured SNMP in switch for this server. I want when I configuring the switch such as spanning-tree or attribute VLAN to any port of switch, the log of this write in solar server. but I don't know what's the configure that I set in switches?

e.g.: when I'm type in switch

#int f0/1

#no switchport

#ip add 192.168.1.1 255.255.255.0

i want the log of this write on solar server like this: user admin typed no switchport & attribute IP address to the int f0/1

[Rob Ingram · Accepted solution]

@chpmotry if you want to track commands configured on network devices, the most appropriate solution is TACACS. This could be Cisco ISE (with the device administration license) or you could use the free tac-plus server.