cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
337
Views
0
Helpful
2
Replies

Source interface based routing

richyvrlimited
Level 1
Level 1

Pretty sure this isn't possible, but worth an ask.

I'd like to policy route some of our traffic based on application awareness. This is all being done by a Sophos XG and then routed via an alternate link to an ASA which is one of our internet /AnyConnect gateways.

As the ASA already has static routes inside for addresses any traffic the Sophos XG policy routes to the ASA is sent back via it's inside interface causing asymmetric routing.

I can fix this by NAT'ing outbound traffic that's been policy routed on the XG, however I can only do the NAT based on source/destination IP, not application awareness

Other than re-architecting the network, can I policy route traffic on the ASA so if the traffic was originally sourced from a specific interface then return traffic would be routed via this interface?

Cheers

2 Replies 2

Hi

 Policy based routing is supported on ASA from version 9.4.1.

https://www.networkstraining.com/cisco-asa-policy-based-routing-pbr/

 

Not really what I asked. I know I can policy route based on source address. What I want to do is policy route based on the original source interface of the connection.

Review Cisco Networking for a $25 gift card