12-03-2015 07:04 AM - edited 03-12-2019 05:50 AM
Hi ,
I'm getting the following error while apply the Sourcefire_3D_Defense_Center_S3_Upgrade-6.0.0-1005.sh
Update Installation Failed: [ 1%] Fatal error: Error running script 000_start/003_check_DC_memory.pl
Any resolution will be appreciate
Thank you.
Solved! Go to Solution.
12-03-2015 07:14 AM
Hi,
This script checks the memory available for the Defense center to use, and 6.0.0 requires a minimum of 6GB of memory, an increase over 5.x versions.
-Shutdown the DC gracefully from the CLI or WebUI
-In vSphere, right-click on the DC, select edit settings.
-Adjust the memory Configuration to allocate a minimum of 6GB to the device and save settings
-Power the DC back on and resume update.
Thanks,
Pujita
12-03-2015 07:14 AM
Hi,
This script checks the memory available for the Defense center to use, and 6.0.0 requires a minimum of 6GB of memory, an increase over 5.x versions.
-Shutdown the DC gracefully from the CLI or WebUI
-In vSphere, right-click on the DC, select edit settings.
-Adjust the memory Configuration to allocate a minimum of 6GB to the device and save settings
-Power the DC back on and resume update.
Thanks,
Pujita
12-03-2015 12:56 PM
Correct , After upgrade to 6GB the update was successfully . Thank you.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide