Static DHCP lease in Pix dhcpd?

[jilahbg]

Hi

Is it possible to do any of this in the Pix:

1) Static DHCP lease. I e configure the Pix's dhcpd to always give a dhcp client with Mac-address xxx the same IP-address yyy?

2) Static ARP entry? I e to configure the pix ARP-table (on inside) that the Mac-address xxx always have the IP-adress yyy?

The reason I want to do this is that I have a hub and spoke VPN-network. On each "spoke" (regional office) LAN there is a Pix 501 with 2-4 PC:s but I only want _1_ of the PC:s to access-the VPN-tunnel. Today I specify the whole spoke Lan in the VPN access-list but I want to change it to only one IP and wants to avoid the users changing IP-addresses on the PC:s to reach the VPN and main office.

Thanks in advance!

Regards Jimmy

[scoclayton]

1) No

2) Yes - http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_sw/v_63/cmdref/ab.htm#wp1127855

The PIX DHCP server is designed as a simple DHCP server in environments where another DHCP server is not feasible (ie a Home Office setup). In most cases, features such as static address assignment are not necessary. If this is something you need, I would suggest talking with your local Cisco account team and asking them to raise an enhancement request on your behalf.

Scott