05-18-2012 07:24 AM - edited 03-11-2019 04:08 PM
Hi, I have put 2 physicl interfaces (te0/8 & 9) on the ASA-5585 into a PO and am assigning ips/vlans to the sub-interfaces. I have 2 issues: - Why am I not able to ping the other sub-interface from the ASA itself? (I can ping the 1st one), Secondly, why the IPs are not visible in "sh int ip brief" ?Although I can see them in "sh ip" ..
/actNoFailover(config-if)# int po17.100
/actNoFailover(config-subif)# vlan 100
/actNoFailover(config-subif)# ip add
/actNoFailover(config-subif)# ip address 100.1.1.1 255.255.255.0
/actNoFailover(config-subif)# int po17.101
/actNoFailover(config-subif)# vlan 101
/actNoFailover(config-subif)# ip address 101.1.1.1 255.255.255.0
/actNoFailover(config-subif)# int po17.102
/actNoFailover(config-subif)# vlan 102
/actNoFailover(config-subif)# ip address 102.1.1.1 255.255.255.0
/actNoFailover(config-subif)# ping 100.1.1.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 100.1.1.1, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 30/32/40 ms
/actNoFailover(config-subif)# ping 101.1.1.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 101.1.1.1, timeout is 2 seconds:
?????
/actNoFailover(config)# sh int ip brie
Interface IP-Address OK? Method Status Protocol
TenGigabitEthernet0/8 unassigned YES unset up up
TenGigabitEthernet0/9 unassigned YES unset up up
Port-channel17 unassigned YES unset up up
Port-channel17.100 unassigned YES manual up up
Port-channel17.101 unassigned YES manual up up
Port-channel17.102 unassigned YES manual up up
Please advise?
05-18-2012 07:58 AM
Ok, i found the answer: - You have to assign "nameif" to the subinterfaces, they are pinging now and also the ips are visible in "sh int ip brief".
05-18-2012 10:03 PM
Hello Sande,
That is correct! Please mark this question as answered so future users having a similar problem can learn from your
solution.
Regards,
Julio
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide