threat-detection basic-threat command does not show up in the running configuration

[jhonnywblue]

When I enter "show run | i threat", I don't see threat-detection basic-threat command in the output even though I configured it.

[Aditya Ganjoo]

Hi,

Can you please use the command show run all threat-detection and check?

Regards,

Aditya

Please rate helpful and mark correct answers

[jhonnywblue]

Upon running "show run all threat-detection" command, I do see the "threat-detection basic-threat" line on the console output but then why it doesn't show when I run "show run | i threat" command. The reason why I am asking this is because I am getting the output on another ASA (same model) upon running the "show run | i threat" command. 

By the way.. Thank you for your help!

[Aditya Ganjoo]

Hi,

If you have configured any changes in the default config then only it would show the config.

If not then it wont show under show run | in threat.

So only manual changes by you would reflect under threat-detection.

Regards,

Aditya

Please rate helpful and mark correct answers

[jhonnywblue]

When you say default config means startup configuration?

Well, I did not make any changes to startup-configuration and still it shows on the console output of ASA # 2 on running "show run | i threat" command.

Oppositely, When I manually added the line "threat-detection basic-threat" command to the running configuration of ASA # 1, and then save the running config to startup config, still the ASA # 1 did not show "threat-detection basic-threat" line on running "show run | i threat" command.

[Aditya Ganjoo]

Hi,

Basic threat detection is enabled by default on all ASAs running 8.0(2) and later. 

Regards,

Aditya

Please rate helpful and mark correct answers