11-26-2007 02:08 AM - edited 03-11-2019 04:35 AM
Dears,
i have Firewall with 4 ports FE is configured as transparent mode..... how many interfaces i can configure in this mode.
i heared just one output interface and one input interface i can configure in this mode...is that true?
or can i configure 2 FE as output and 2 FE as Input.
thx for any advice or help.
11-26-2007 11:52 PM
Hi,
Kindly provide the software and hardware details of your firewall.
regards
Sachin Verma
11-27-2007 07:20 AM
it is ASA5510 and software ASA Version 7.2(2) .
02-14-2008 07:45 PM
Hi,
Dou you have info about this ?
Can you configure only 2 or 4 interfaces ?
Regards
02-17-2008 11:25 AM
Greetings,
Accoding to the ASA manual:
Note Transparent firewall mode allows only two interfaces to pass through traffic; however, on the The ASA 5510 and higher adaptive security appliance, you can use the Management 0/0 interface (either the physical interface or a subinterface) as a third interface for management traffic. The mode is not configurable in this case and must always be management-only.
Also if you desire yopu can configure your device in multiple context mode and use all 4 interfaces. 2 for each context.
Hope this helped.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide