Hi,
Got my FPR 1010 FTD running between my ISP and UDM PRO all is more or less good.
Sry for any stupid questions still a little green in the field.
I'm starting to see a high amount of TX retries for my 2 AP's, this has started after the FPR was introduced into the network.
I can see packets are being dropped on the outside interface 1/2, pasted the stats below.
Can these packet drops be the reason behind the retires, if so what can i do?
Interface Vlan1 "inside", is up, line protocol is up
Hardware is EtherSVI, BW 100 Mbps, DLY 100 usec
MAC address 4488.16d0.8985, MTU 1500
IP address 10.100.XX.XXX, subnet mask 255.255.255.0
Traffic Statistics for "inside":
37605 packets input, 11841737 bytes
243090 packets output, 315562324 bytes
691 packets dropped
1 minute input rate 26 pkts/sec, 7314 bytes/sec
1 minute output rate 74 pkts/sec, 77610 bytes/sec
1 minute drop rate, 0 pkts/sec
5 minute input rate 26 pkts/sec, 6573 bytes/sec
5 minute output rate 101 pkts/sec, 121061 bytes/sec
5 minute drop rate, 1 pkts/sec
Control Point Interface States:
Interface number is 15
Interface config status is active
Interface state is active
Interface Ethernet1/1 "outside", is up, line protocol is up
Hardware is EtherSVI, BW 1000 Mbps, DLY 10 usec
MAC address 4488.16d0.89c8, MTU 1500
IP address 84.23.XXX.XXX, subnet mask 255.255.255.0
Traffic Statistics for "outside":
234706 packets input, 305409793 bytes
35325 packets output, 10867558 bytes
1183 packets dropped
1 minute input rate 74 pkts/sec, 77614 bytes/sec
1 minute output rate 26 pkts/sec, 7039 bytes/sec
1 minute drop rate, 0 pkts/sec
5 minute input rate 102 pkts/sec, 123390 bytes/sec
5 minute output rate 24 pkts/sec, 5689 bytes/sec
5 minute drop rate, 2 pkts/sec
Control Point Interface States:
Interface number is 7
Interface config status is active
Interface state is active
Interface Ethernet1/2 "", is up, line protocol is up
Hardware is EtherSVI, BW 1000 Mbps, DLY 10 usec
