I am having a problem configuring any interface on my ASA 5510 running ASA 8.2.1. When i try to configure an interface I am unabl eto assign an IP addres, security level, name the interface or do anythingt else that would allow me to use the device. When I hit the "?" to see the allowed command I recieve the following:
corpfir01(config)# interface ethernet 0/1
Interface configuration commands: default Set a command to its defaults description Interface specific description dhcp Configure parameters for DHCP client duplex Configure duplex operation exit Exit from interface configuration mode help Interactive help for interface subcommands no Negate a command or set its defaults shutdown Shutdown the selected interface speed Configure speed operation corpfir01(config-if)#
Radius server configuration for 802.1X
Server radius test1
Address ipv4 10.1.1.1
Server radius test2
Address ipv4 10.1.1.2
aaa group server radius TEST-gr
server name test1
server name test2
Umbrella’s cloud-delivered firewall (CDFW) is a cool features that provides Firewall Services in the Cisco Umbrella Cloud without the need to deploy on-premises firewall devices and visibility and control for internet traffic across all branch offices. To...
SymptomsDownloadable ACL (dACL) does not take effect on the IOS-XE Network Access DevicesDiagnosisCreating redirection ACL on the IOS-XE device failed to redirect the specified traffic for captive portal redirectionSolutionEnable device tracking, Below is...
Multiple Cisco Security Technologies in a single book : ASA Firepower, WSA, Umbrella, ISE and VPN with 100 percent 100 practical scenarios with 70 Labs to cover important topics of the Cisco SCOR Exam. The best part is ISE with interesting scenarios wi...