Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a newly upgraded ASA 5516 that was previously running ASA OS and is now running FTD. For some reason the Management1/1 interface is admin down, line up.
Interface Management1/1 "diagnostic", is administratively down, line protocol is up Hard...
I have a pair of Nexus 3548 switches running 6.0(2)A6(4) acting as cores connected to a stack of two c3850 switches running 03.02.03.SE over 10G uplinks.
The physical configuration has Nexus 3548 core switch 1 connected c3850 stack chassis 1 and 354...
I have two brand new aironet 1702I-A lightweight access points that I am trying to join to a new WLC 2504 running 8.0.100.0, I can see the discovery request come in but shortly after the following entry is logged by debug capwap on the controller:*sp...
When I try to enable sflow via "feature sflow" command on the nexus 3548 switches running 6.0(2)A1(1C) I receive:Error: while enabling/disabling service: sflow, err: service not found (0x401e0005) Any input would be greatly appreciated.Thank you
I am trying to utilize a SIP trunk to stream voice traffic to an asterisk Contact Center solution using a dial plan, the problem that I am running into is I am able to see the ANI or the DNIS by messing with the "Calling Party Selection" in the "Outb...
The only solution I found was to use a Netflow generator that would sit on a SPAN port, I am currently using nProbe by NTOP but there are multiple solutions out there.Ryan
I opened a ticket with Cisco TAC after seeing bug ID CSCur50946, which seems to be a incorrect or corrupt certificate on access points manufactured in September or October of 2014. I am awaiting the delivery of the new units. Thank you for your respo...
